This guide offers you two methods to fix this error. But before I get to that, I will explain three things that could cause this error. After that, you can read the steps to fix this problem.

3 Reasons You May Receive “Scanning and Repairing Drive” Error In Windows 11

In the following subsection, I explain 3 topmost reasons.

If You Forcefully Shutdown Your Computer

If you shut down your computer by pressing and holding the power button, Windows will not do a “clean” shut down. This may lead to some file corruption. If some Operating System files get corrupted, it may trigger the “scanning and repairing drive” error in Windows 11.

If You Run CHKDSK With The /F Switch

CHKDSK is a Windows command you can use to scan a Windows disk for file system errors. If you run the CHKDSK command with the /F switch on the Windows installation drive while logged on, the command cannot be completed. Rather, you’ll receive the message below: If you enter Y and press the enter key, the next time your Windows 11 PC restarts, it will display “scanning and repairing drive.” Ideally, this process should run smoothly, and your computer should start normally. However, your Windows 11 computer may be stuck on the “scanning and repairing drive” screen on rare occasions.

If Your Hard Disk Has Some Corrupt Sectors

This is yet another reason you may receive the “scanning and repairing drive” error. If the storage disk on your PC has bad sectors, it may also trigger Windows 11 to try to repair the bad sections. Therefore, you may see the “scanning and repairing drive” message when you restart the computer. As I mentioned earlier, this process should go smoothly. Unfortunately, Windows 11 may sometimes be stuck in the “scanning and repairing drive” window. Having explained three primary reasons you may receive this error message, I will now walk you through the steps to fix the error.

Step 1: Boot Windows 11 To Safe Mode

Step 2: Use One Of The Methods Below To Fix The “Scanning And Repairing Drive” Windows 11 Error

Once your computer has started in Safe mode, use one of the methods I described in this section to fix the cause of the problem.

Method 1: Check Your Windows 11 Installation Drive For File System Errors

Earlier in this guide, I mentioned that you might receive the “Scanning And Repairing Drive” Windows 11 error because your computer’s disk has bad sectors. If this is what is causing the error, you can fix it using the steps below: Try my next recommendation if the steps in method 1 above do not fix the “Scanning And Repairing Drive” Windows 11 error.

Method 2: Run CHKDSK And Restart Your Computer

Running this command in Run will open the System32 folder. You will still see “Scanning and Repairing Drive” when you restart your computer. Do not panic. This time, the CHKDSK command initiated the scan. It should scan successfully and boot your computer normally.

“Scanning and Repairing Drive” Error In Windows 11: My Final Thoughts

In this guide I have explained 3 reasons your Windows 11 PC may display the “Scanning and Repairing Drive” error. Then, I offered a step-by-step guide to fix the problem. For a quick summary, to fix this error, first boot your Windows 11 to Safe mode. Then, run disk check on the drive in question. Alternatively, while signed in to your PC in Safe mode, run CHKDSK with the /F switch, then restart your computer. I hope you were about to use the steps in this guide to get your PC to work again? If you found the gude helpful, click Yes to Was this helpful? below. You may also provide us with detailed feedback or share your experience with the “Scanning and Repairing Drive” error with other readers. Use the “Leave a Reply” form at the end of this page to share your thoughts. Finally, for more Windows 10 Itechguides, visit our Windows 11 How-to page. You may also find our Windows 10 How-to page very informative.

Δ